The MINUTEMAN PRO-E. Series of Uninterruptible Power Supplies (UPS)
delivers complete protection from electrical problems . spikes,
surges, sags, brownouts, and blackouts. The PRO1100E are only slightly
larger in physical size, yet each offers an expansive six (6) outlets with
battery backup and surge protection and heavy power-handling
capabilities found in much larger-sized models. This size-to-power
ratio makes them ideal for high-power requirement devices installed
in cramped quarters.
Manufacturer
Para Systems, Inc
Manufacturer Part Number
PRO1100E
Manufacturer Website Address
www.minutemanups.com
Brand Name
Minuteman
Product Line
PRO-E
Product Series
E
Product Name
PRO1100E UPS
Product Type
Line-interactive UPS
Technical Information
Plug/Connector Type
NEMA 5-15P
Receptacles
6 x NEMA 5-15R - Backup/Surge-protected
Switching Time
6 ms
Dataline Protection
RJ-45 Network
Power Description
Load Capacity
1100VA/770W
Input Voltage
110V AC
Input Voltage Range
75V AC to 145V AC
Output Voltage
105 to 136V AC
Frequency
60Hz
Voltage Handling
±1% % Battery Regulation
Waveform Type
Simulated Sine Wave
Surge Energy Rating
500J
Filtering
EMI/RFI
Management
Network Management
SNMP Manageable Included
Alarm
Battery Disconnected
Controls/Indicators
Status Indicators
Ac normal
Boost mode
Buck mode
Battery mode
Internal fault
Over-current
Battery fault: Weak, bad or disconnected battery
Site-wiring fault
Interfaces/Ports
USB
Battery Information
Batteries
User-replaceable Hot-swappable
Backup/Run Time
21.6 Minute 385W Half-load
Battery Recharge Time
8 Hour Maximum
Physical Characteristics
Dimensions
8.03" Height x 6.38" Width x 16.18" Depth
Shipping Dimensions
13" Height x 12.6" Width x 22.8" Depth
Weight
39.24 lb
Shipping Weight
43 lb
Miscellaneous
Package Contents
PRO1100E UPS
USB and RS232 cables
MINUTEMAN SentryII power management and diagnostic software
Additional Information
Built-in double-boost and single-buck AVR (Automatic Voltage Regulator)
Independent Battery Bypass
Replacement battery description:
12 Volt
7.2 Amp Hour
Designed for protection of:
PCs
Telephone Systems
Data Communications
System Requirements
Operating System supported by SentryII software:
Microsoft Windows 95/98/ME/NT4/XP/2000/2003 with Service Pack 6 recommended for Windows NT 4.0
